Watch Videos

Page 11

Using Thermal Camera to inspect a PCB (with FLIR ONE PRO)

This video shows how a PCB or electronic circuit will look under thermal camera FLIR ONE PRO.

Cadence Allegro Tutorial - How to create SKILL Script

This video explains how you can create, run and use SKILL scripts to create your own commands in Cadence Allegro.

How to design boards that work the first time

About how to design boards that you can sell to your customers as the very first version.

PCB Manufacturing - Important facts you should know

About teardrops, slivers, drilling, coupons, VIAs, plating, 90 Degree corners, thermal relief, cost and more ...

TIP #100: Create a Board Release procedure

Why? You really want to be sure, that you have done all the necessary steps and you have generated all the documents.

TIP #099: Your product should be tested for ESD discharge

Why? If your product is ESD sensitive, you may be risking a lot of returns as ESD discharge is very common.

TIP #098: Don’t forget to place other mounting holes

Why? It may be very difficult to add mounting holes into already routed area.

TIP #097: During layout, consider to hide designators

Why? It makes PCB much easier to work with during layout.

TIP #096: Place SCH pins the easy to read and consistent way

Why? It helps to create easy to read and easy to understand schematics.

TIP #095: Place components before you start doing layout

Why? Sometimes it can be very difficult to add components into already routed areas.

TIP #094: Don’t use 4 wire cross junctions

Why? In some cases it is not clear if the signals are connected or if wires are just crossing.

TIP #093: Put big and small titles into your schematic

Why? It helps everyone read and understand your schematic very quickly.

TIP #092: Under a component with exposed pad (EP), ...

Why? It’s easy to connect them to GND and it keeps current loops small.

TIP #091: Mark components which you may not want to fit

Why? So you don’t forget about them until you are ready to create variants.

TIP #090: Crystals can be placed also on the opposite side

Why? Sometimes you may be very limited in space and it can be the only way to place the crystal. Tested on many boards, it works.

Pages: 1 2 3 4 5 6 7 8 9 10 <11> 12 13 14 15 16 17 18 19 20 21 22 23